SoliForum - 3D Printing Community — Help, printer/filament issues!

Re: Help, printer/filament issues!

2015-05-08T18:39:47Z

20% infill and the speed I will have to check when I get home

Re: Help, printer/filament issues!

2015-05-08T17:49:25Z

ArcticWolf_11 wrote:

Hi, I just recently got my Da Vinci 1.0a printer and when I tried printing something it would turn out fine but when it reaches the top layer where it covers the hollow inside of my print, it prints the filament very thinly and when its done it looks like a wire frame. My printer is using Repetier 0.92 and im using the repetier software too. Is there some sort of setting that I need to enable/fix to make my prints come out good? My settings were 0.2mm and honeycomb inner structure (I forgot the exact name of the setting and I cant check it now because I am at school, but I think you guys get what I mean). Thanks and sorry if I missed anything else, first time on the forums too.

What percentage is your infill set to and what speed is the infill set to?

Help, printer/filament issues!

2015-05-08T15:43:53Z

Hi, I just recently got my Da Vinci 1.0a printer and when I tried printing something it would turn out fine but when it reaches the top layer where it covers the hollow inside of my print, it prints the filament very thinly and when its done it looks like a wire frame. My printer is using Repetier 0.92 and im using the repetier software too. Is there some sort of setting that I need to enable/fix to make my prints come out good? My settings were 0.2mm and honeycomb inner structure (I forgot the exact name of the setting and I cant check it now because I am at school, but I think you guys get what I mean). Thanks and sorry if I missed anything else, first time on the forums too.