SoliForum - 3D Printing Community — Tried updating firmware, it isn't uploading

Re: Tried updating firmware, it isn't uploading

2015-05-02T01:52:45Z

Are you sure you have the correct com port selected in RH.
you'll also want to make sure "auto reset on connect" is disabled in RH.

Re: Tried updating firmware, it isn't uploading

2015-05-02T00:05:24Z

Now I was able to flash it and boot, printer still doesn't respond.

Re: Tried updating firmware, it isn't uploading

2015-05-01T23:26:27Z

wardjr wrote:

No other way and I know it looks daunting but really isn't that bad. I have done it many times as have many other users. Should only take a first timer an hour and after that it's about a 10 minute thing. Good luck

Computer doesn't seem to be recognizing the board after booting.

Re: Tried updating firmware, it isn't uploading

2015-05-01T23:08:14Z

No other way and I know it looks daunting but really isn't that bad. I have done it many times as have many other users. Should only take a first timer an hour and after that it's about a 10 minute thing. Good luck

Re: Tried updating firmware, it isn't uploading

2015-05-01T22:45:29Z

wardjr wrote:

That's a printerboard follow the printerboard instructions on the WIKI.

Any other way? When I'm at the last steps I get a message from the command prompt that the BootloaderHId is not recognized as an internal or external command.

Re: Tried updating firmware, it isn't uploading

2015-05-01T22:14:17Z

That's a printerboard follow the printerboard instructions on the WIKI.

Re: Tried updating firmware, it isn't uploading

2015-05-01T21:58:39Z

Here it is, thank you.

Re: Tried updating firmware, it isn't uploading

2015-05-01T21:52:35Z

Take a picture and post it I'll tell you.

Re: Tried updating firmware, it isn't uploading

2015-05-01T21:46:38Z

wardjr wrote:

Make sure you have the correct board chosen in configuration.h.
Also in Arduino under tools you need to select the correct board. If it isn't in the drop down under "board" then you need to locate that hardware folder and move it to the correct location.

How can I make double check my board? I'm using the one according with the instructions. "Sanguino W/ ATmega644P"

Re: Tried updating firmware, it isn't uploading

2015-05-01T21:29:05Z

Make sure you have the correct board chosen in configuration.h.
Also in Arduino under tools you need to select the correct board. If it isn't in the drop down under "board" then you need to locate that hardware folder and move it to the correct location.

Tried updating firmware, it isn't uploading

2015-05-01T21:22:01Z

Hello everyone,

I tried to flash the firmware with the hysteresis fix, downloaded it here and followed instructions.
https://github.com/ozadr1an/Solidoodle- … in_v1_beta

I'm getting this error "avrdude: stk500_getsync(): not in sync: resp=0x00" after trying to upload it in Arduino 1.0.5, now the 3d printer connects to the slicer but doesn't react to any instructions. I've a Solidoodle 3.