<![CDATA[SoliForum - 3D Printing Community — Extrusion not working after a 10 minutes of printing]]> 2013-02-03T16:03:37Z PunBB https://www.soliforum.com/topic/1092/extrusion-not-working-after-a-10-minutes-of-printing/ <![CDATA[Re: Extrusion not working after a 10 minutes of printing]]> chuey wrote:

Turns out the heating up and shutting off was caused by my computer going to sleep.

I am still have a lot of problems though.
My nozzle only leaves crumbs behind now. This is my second nozzle. Also I tried using the settings from another guy I know who has one and has no problems and still nothing works right.

Tell us more about the issue. What do you mean by crumbs?

]]> https://www.soliforum.com/user/7/ 2013-02-03T16:03:37Z https://www.soliforum.com/post/11641/#p11641 <![CDATA[Re: Extrusion not working after a 10 minutes of printing]]> Turns out the heating up and shutting off was caused by my computer going to sleep.

I am still have a lot of problems though.
My nozzle only leaves crumbs behind now. This is my second nozzle. Also I tried using the settings from another guy I know who has one and has no problems and still nothing works right.

]]> https://www.soliforum.com/user/565/ 2013-01-28T19:08:05Z https://www.soliforum.com/post/10954/#p10954 <![CDATA[Re: Extrusion not working after a 10 minutes of printing]]> In Repetier-Host, what d your temp graphs look like?

If they are erratic, perhaps this accounts for some of your problems. Maybe you could post a screenshot?

]]> https://www.soliforum.com/user/51/ 2013-01-24T01:30:10Z https://www.soliforum.com/post/10418/#p10418 <![CDATA[Extrusion not working after a 10 minutes of printing]]> I am now on my second hot-end and my problem continues.

When I print I get a few minutes into it and then the plastic just stops coming out of the extruder. The extruder motor will then dig a hole in the filament.

I got a little better results when I set my speeds to 30 instead of 60. I also set the extrusion multiplier to 0.7. I saw a video where a guy was calibrating his extruder and ran 100 mm through at full speed. I cannot run more that 2mm at a time or the gear digs a hole in the filament.

When I set the temperature to 200 it seems like the extrusion works a little better but eventually the control of the temperature freaks out and it spikes up to 215 and then turns off.

I have not been able to printout more than 4-5 prints since I got the thing because of this problem. Has anybody seen this?

I was thinking maybe the temperature read back from the extruder wasn't right or something.

Thanks for any help.

]]> https://www.soliforum.com/user/565/ 2013-01-23T21:24:43Z https://www.soliforum.com/post/10399/#p10399