<![CDATA[SoliForum - 3D Printing Community — Can XYZ understand G2,G3 or is it only G1?]]> 2015-04-24T06:40:58Z PunBB https://www.soliforum.com/topic/10894/can-xyz-understand-g2g3-or-is-it-only-g1/ <![CDATA[Re: Can XYZ understand G2,G3 or is it only G1?]]> If your circles are bad then your bearing mounts are cracked or there is side to side play between the white pullies and retaining washers. May need to shim them.

]]> https://www.soliforum.com/user/7731/ 2015-04-24T06:40:58Z https://www.soliforum.com/post/93968/#p93968 <![CDATA[Re: Can XYZ understand G2,G3 or is it only G1?]]> im currently on
XYZ Da Vinci 1.0A
Repetier .92MOD


do you know if there is another version that i can change it to so that i can understand?
Cause these circle is looking pretty bad.

]]> https://www.soliforum.com/user/9300/ 2015-04-24T05:50:52Z https://www.soliforum.com/post/93964/#p93964 <![CDATA[Re: Can XYZ understand G2,G3 or is it only G1?]]> There is also G0 but the firmware that the XYZ uses only knows G1 commands. It is not a slicer limitation. But how the firmware interprets it and this firmware cannot interpret fast moves.

]]> https://www.soliforum.com/user/7731/ 2015-04-24T05:48:21Z https://www.soliforum.com/post/93962/#p93962 <![CDATA[Can XYZ understand G2,G3 or is it only G1?]]> Hello all, I'm currently taking a CAD/CAM design class.
After looking at my GCode from Slic3r i realized that there is no G2 or G3?
So my question is can XYZ understand G2/G3 or is it that slic3r only give out G1?

]]> https://www.soliforum.com/user/9300/ 2015-04-24T05:38:03Z https://www.soliforum.com/post/93961/#p93961