2015-04-23T18:32:43Z PunBB https://www.soliforum.com/topic/10885/broken-ceramic-pad-on-heat-element-block/ Will do jagowilson. Of course you both know since you are in my other thread discussion that I am probably going to upgrade it anyways. I'll just need it to be able to print the items i need to make the change.

]]> https://www.soliforum.com/user/8991/ 2015-04-23T18:32:43Z https://www.soliforum.com/post/93912/#p93912 You may want to re-run your PID calibrations just to be sure your temps remain stable. Check the wiki on how to do this, it's very simple.

]]> https://www.soliforum.com/user/7321/ 2015-04-23T18:13:31Z https://www.soliforum.com/post/93907/#p93907 You'll be fine even without the tape.

]]> https://www.soliforum.com/user/2291/ 2015-04-23T17:51:15Z https://www.soliforum.com/post/93903/#p93903 So I was removing the nozzle to clean a clog and I cracked half of one of the "ceramic" pads off that cover and insulate the electrodes on the heating element block. When I put it all back together I put it back over and wrapped some Kapton around the block to hold it on. Should I be concerned about this or will my fix be ok? I have not printed anything yet since it happened.

]]> https://www.soliforum.com/user/8991/ 2015-04-23T15:37:58Z https://www.soliforum.com/post/93869/#p93869