<![CDATA[SoliForum - 3D Printing Community — Da Vinci 1.0 Version 1.1.1 refusing to slice my model properly]]> 2015-04-22T02:19:42Z PunBB https://www.soliforum.com/topic/10868/da-vinci-10-version-111-refusing-to-slice-my-model-properly/ <![CDATA[Re: Da Vinci 1.0 Version 1.1.1 refusing to slice my model properly]]> PseudoShooter wrote:

This has happened to me in the past on a few .stl I had got off of Thingiverse. Netfabb fixed them right up.

The golden rule with thingiverse is that if see a model but no one has posted their own print of it, chances it needs to be fixed or is just unprintable. Thingiverse caters to 3d modeling in general, not just printing. So much of the stuff was never intended to be printed or the designer was unaware of the limitations of 3d printers.

]]> https://www.soliforum.com/user/7731/ 2015-04-22T02:19:42Z https://www.soliforum.com/post/93727/#p93727 <![CDATA[Re: Da Vinci 1.0 Version 1.1.1 refusing to slice my model properly]]> This has happened to me in the past on a few .stl I had got off of Thingiverse. Netfabb fixed them right up.

]]> https://www.soliforum.com/user/9457/ 2015-04-22T02:01:50Z https://www.soliforum.com/post/93725/#p93725 <![CDATA[Re: Da Vinci 1.0 Version 1.1.1 refusing to slice my model properly]]> DaftPrune wrote:

What I expect:http://soliforum.com/i/?fW4kxBX.png



What I get:http://soliforum.com/i/?D5huH4h.png

Run the file through a service like netfabb then try it.

It could also just be the common video glitch. The sliced file is there, just does not show up. Have tried to go ahead and send it to the printer?

]]> https://www.soliforum.com/user/7731/ 2015-04-22T00:14:41Z https://www.soliforum.com/post/93718/#p93718 <![CDATA[Da Vinci 1.0 Version 1.1.1 refusing to slice my model properly]]> What I expect:http://soliforum.com/i/?fW4kxBX.png



What I get:http://soliforum.com/i/?D5huH4h.png

]]> https://www.soliforum.com/user/10552/ 2015-04-21T23:53:51Z https://www.soliforum.com/post/93716/#p93716