<![CDATA[SoliForum - 3D Printing Community — not extruding]]> 2013-01-22T15:22:17Z PunBB https://www.soliforum.com/topic/1083/not-extruding/ <![CDATA[Re: not extruding]]> turns out it was the grub screw that holds the toothed cog onto the drive shaft of the extruder motor, quick tighten, and away again...
(getting a bit fed up of cutting the back of my hands on this frame though !!)

]]> https://www.soliforum.com/user/456/ 2013-01-22T15:22:17Z https://www.soliforum.com/post/10226/#p10226 <![CDATA[Re: not extruding]]> saymo606 wrote:

I received my new hot end from SD, ran autotune, no probs, but it is not extruding abs...? I can hear the extruder motor trying to turn, but if i look at it while i hit extrude it does not turn.. if i push the abs down into the extruder, it turns?

any ideas?

sounds like pressure of the idler roller or is your extruder in need of a cleaning?
Those teeth get filled with plastic, forget feeding.

]]> https://www.soliforum.com/user/681/ 2013-01-22T13:58:11Z https://www.soliforum.com/post/10218/#p10218 <![CDATA[not extruding]]> I received my new hot end from SD, ran autotune, no probs, but it is not extruding abs...? I can hear the extruder motor trying to turn, but if i look at it while i hit extrude it does not turn.. if i push the abs down into the extruder, it turns?

any ideas?

]]> https://www.soliforum.com/user/456/ 2013-01-22T13:04:35Z https://www.soliforum.com/post/10215/#p10215