<![CDATA[SoliForum - 3D Printing Community — RH Bed Probe]]> 2015-03-04T12:39:52Z PunBB https://www.soliforum.com/topic/10258/rh-bed-probe/ <![CDATA[Re: RH Bed Probe]]> jagowilson wrote:

You only need it in one place. Putting the code in both spots puts it in the print twice.

Thank you

This has resolved it

]]> https://www.soliforum.com/user/7070/ 2015-03-04T12:39:52Z https://www.soliforum.com/post/88220/#p88220 <![CDATA[Re: RH Bed Probe]]> You only need it in one place. Putting the code in both spots puts it in the print twice.

]]> https://www.soliforum.com/user/7321/ 2015-03-04T04:58:43Z https://www.soliforum.com/post/88191/#p88191 <![CDATA[RH Bed Probe]]> Hello All

I edited the start code as suggested by Soliryan in previous threads, but when using RH with the new start code, it is probing the bed two sets before starting printing, is this correct or did I do something wrong?

I put the start code in the preview edit start code but i ALSO put it in the Slicer config, could that be the reason?

Thanks Again

]]> https://www.soliforum.com/user/7070/ 2015-03-04T04:03:05Z https://www.soliforum.com/post/88190/#p88190