<![CDATA[SoliForum - 3D Printing Community — Noise / Vibration coming from Z motor.]]> 2015-02-25T05:45:51Z PunBB https://www.soliforum.com/topic/10147/noise-vibration-coming-from-z-motor/ <![CDATA[Re: Noise / Vibration coming from Z motor.]]> johnrn1967 wrote:

Have you checked the bottom of the printer for the bolts to the bed guides?  Mine were missing installing them helped with some of my vibration issues

Interesting. I am missing those screws. I'll pick some up tomorrow to see if that helps with the sound. I read in another thread they are M4 x 10 or 12.

]]> https://www.soliforum.com/user/9584/ 2015-02-25T05:45:51Z https://www.soliforum.com/post/87139/#p87139 <![CDATA[Re: Noise / Vibration coming from Z motor.]]> Have you checked the bottom of the printer for the bolts to the bed guides?  Mine were missing installing them helped with some of my vibration issues

]]> https://www.soliforum.com/user/9724/ 2015-02-24T18:38:49Z https://www.soliforum.com/post/87029/#p87029 <![CDATA[Re: Noise / Vibration coming from Z motor.]]> I have the same issue. Until I can figure out a proper fix, I just set my Z speed to 1mm/s. It slows down z-probe quote a lot, but at least my bed is not shaking any longer and I'm getting nice prints.

Edit: I'm using Repetier-Host. Updated z speed in EEPROM using RH.

]]> https://www.soliforum.com/user/9017/ 2015-02-24T17:38:51Z https://www.soliforum.com/post/87018/#p87018 <![CDATA[Noise / Vibration coming from Z motor.]]> I'm having an issue where there is noise and vibration happening when the Z motor gets near the top of its range (I'd say within an inch) I've tried grease, tightening the ring with the two pin holes on the top of the Z motor, tightening the bed screws on the bottom. Nothing has worked in removing this yet.

Any ideas?

]]> https://www.soliforum.com/user/9584/ 2015-02-24T15:11:55Z https://www.soliforum.com/post/86996/#p86996