1

Topic: A lion with a "hairy" mane...

Not sure if anyone else here has tried this print, but I saw it posted in a facebook group and had to give it a shot...

http://www.thingiverse.com/thing:2007221

turned out pretty well it think - printed in Hatchbox Gold ABS.

during printing...

http://soliforum.com/i/?ADwsSUU.jpg

after removing the outer shield...

http://soliforum.com/i/?GEjAfbG.jpg

and after "styling" the mane with a heat gun...

http://soliforum.com/i/?OxepyBe.jpg

SD4 #1 & #2 - Lawsy carriages, E3D v6, Rumba controller board, mirror bed plate, X motor fan, upgraded PSU & Mica bed heater
SD4 #3 - in the works ~ Folgertech FT-5, rev 1
Printit Industries Beta Tester - Horizon H1

2

Re: A lion with a "hairy" mane...

That's pretty damn cool!

Printit Industries Model 8.10 fully enclosed CoreXY, Chamber heat
3-SD3's & a Workbench all fully enclosed, RH-Slic3r Win7pro, E3D V6, Volcano & Cyclops Hot End
SSR/500W AC Heated Glass Bed, Linear bearings on SS rods. Direct Drive Y-axis, BulldogXL
Thanks to all for your contributions

3

Re: A lion with a "hairy" mane...

wow,  that's cool!

To print or, 3D print, that is the question...
SD3 printer w/too many mods,  Printrbot Simple Maker Ed.,  FormLabs Form 1+
AnyCubic Photon, Shining 3D EinScan-S & Atlas 3D scanners...
...and too much time on my hands.

4

Re: A lion with a "hairy" mane...

thanks guys. smile

it was kind of a pain to trim the shield off, but once that is done, the "styling" part is pretty easy. Just have to be careful of how long you hold the heat gun in one spot

it does lose some of the "hair" during trimming and in the "styling" process, but there is plenty of it so no big deal.

SD4 #1 & #2 - Lawsy carriages, E3D v6, Rumba controller board, mirror bed plate, X motor fan, upgraded PSU & Mica bed heater
SD4 #3 - in the works ~ Folgertech FT-5, rev 1
Printit Industries Beta Tester - Horizon H1