Topic: updated firmware now only prints on the left edge of bed?
Hi Just upgraded to lead screws for the z axis. Had to re due firmware (marlin) on a ramps 1.4 board and now it only prints on the far edge of the glass? I am not sure why?
You are not logged in. Please login or register.
SoliForum - 3D Printing Community → Software & Firmware → updated firmware now only prints on the left edge of bed?
Hi Just upgraded to lead screws for the z axis. Had to re due firmware (marlin) on a ramps 1.4 board and now it only prints on the far edge of the glass? I am not sure why?
And why would you redo firmware to install a lead screw.
Z steps can be changed via RH without reloading firmware.
Did you load the same firmware you were using ?
What printer do you have.
sounds like some settings are different check your x and y max settings
SoliForum - 3D Printing Community → Software & Firmware → updated firmware now only prints on the left edge of bed?
Powered by PunBB, supported by Informer Technologies, Inc.