Topic: Bricked Da Vinci 1.1 plus
Hopefully i can recover my bricked 1.1 plus, i reset the chip and the realised that 1.1 plus is not supported with the non OEM firmware.
I would be greatful for any ideas to recover thos unit.
Thanks in advance.
You are not logged in. Please login or register.
SoliForum - 3D Printing Community → Software & Firmware → Bricked Da Vinci 1.1 plus
Hopefully i can recover my bricked 1.1 plus, i reset the chip and the realised that 1.1 plus is not supported with the non OEM firmware.
I would be greatful for any ideas to recover thos unit.
Thanks in advance.
If you are feeling adventurous, you could always try swapping out the controller board & firmware for something open source...
:-) drop from a second story window would be more fun :-)
:-) drop from a second story window would be more fun :-)
LOL, most likely.
ive read elsewhere that holding the up and down buttons on the face of the unit while powering it up will bring it to bootloader as well some say left and right held at power up .... worth a try
SoliForum - 3D Printing Community → Software & Firmware → Bricked Da Vinci 1.1 plus
Powered by PunBB, supported by Informer Technologies, Inc.