1 Topic by Morganism

  • Morganism
  • Member
  • Offline
  • Registered: 2015-01-19
  • Posts: 133

Topic: New article about the state of 3d printing

http://seekingalpha.com/article/3959502 … estruction

Thought it was interesting

Solidoodle 4-Mostly stock running off headless Raspberry Pi with Octoprint

2 Reply by heartless

  • heartless
  • heartless
  • Member
  • Offline
  • From: Northcentral Wisconsin
  • Registered: 2015-04-08
  • Posts: 2,152

Re: New article about the state of 3d printing

could have been interesting until the "register to finish reading" thing popped up. sad

SD4 #1 & #2 - Lawsy carriages, E3D v6, Rumba controller board, mirror bed plate, X motor fan, upgraded PSU & Mica bed heater
SD4 #3 - in the works ~ Folgertech FT-5, rev 1
Printit Industries Beta Tester - Horizon H1

3 Reply by TickTock

  • TickTock
  • TickTock
  • Member
  • Offline
  • Registered: 2014-05-28
  • Posts: 263

Re: New article about the state of 3d printing

A quick shift-PrintScreen will let you read pg2 (then paste into something).   Not really worth the trouble, though.  Have to be more creative to see pg3 but nothing there except a disclaimer.

4 Reply by wardjr

  • wardjr
  • wardjr
  • Moderator
  • Offline
  • From: Minnesota
  • Registered: 2013-06-10
  • Posts: 5,623

Re: New article about the state of 3d printing

The whole thing shows from my smartphone.

Printit Industries Model 8.10 fully enclosed CoreXY, Chamber heat
3-SD3's & a Workbench all fully enclosed, RH-Slic3r Win7pro, E3D V6, Volcano & Cyclops Hot End
SSR/500W AC Heated Glass Bed, Linear bearings on SS rods. Direct Drive Y-axis, BulldogXL
Thanks to all for your contributions

wardjr's Website