1 Topic by dubbsd

  • dubbsd
  • dubbsd
  • Member
  • Offline
  • From: Northwest florida
  • Registered: 2012-09-30
  • Posts: 748

Topic: why did the purge wall do this

does anyone have any suggestions?

http://soliforum.com/i/?tAnqwso.jpg

Ultimaker S3.

2 Reply by wardjr

  • wardjr
  • wardjr
  • Moderator
  • Offline
  • From: Minnesota
  • Registered: 2013-06-10
  • Posts: 5,623

Re: why did the purge wall do this

Looks like under extrusion on that nozzle.  Possible partial clog?  Maybe temp is too low for that filament?

Printit Industries Model 8.10 fully enclosed CoreXY, Chamber heat
3-SD3's & a Workbench all fully enclosed, RH-Slic3r Win7pro, E3D V6, Volcano & Cyclops Hot End
SSR/500W AC Heated Glass Bed, Linear bearings on SS rods. Direct Drive Y-axis, BulldogXL
Thanks to all for your contributions

wardjr's Website

3 Reply by dubbsd

  • dubbsd
  • dubbsd
  • Member
  • Offline
  • From: Northwest florida
  • Registered: 2012-09-30
  • Posts: 748

Re: why did the purge wall do this

Thanks wardjr
I put that on my list of things to check.
I haven't had any trouble until last week and everything has started going bad.
I have about 600 hrs on the machine so I guess it is time to CLEAN, REPAIR & or REPLACE parts

I think my nozzles are out of align

PS.  Filament Ø measures OK. and temp ok.

Ultimaker S3.