26 Reply by FatalDischarge

  • FatalDischarge
  • Member
  • Offline
  • From: Arvada, CO
  • Registered: 2012-12-30
  • Posts: 129

Re: Power Supply Upgrade - 500W for $12

Krythis wrote:
Sooks569 wrote:

Thanks for the pic, I just used standard computer jumpers for those pins.  So, as far as the screws are concerned do I  really even need to have them installed?  I used what we call in work "backshell tape".  It's silicon tape that adheres to itself to act as a rubber "washer".  I still get continuity between the case and the main power supply terminals on the connector though.

I'm hoping to add a switch for PS ON and having a hard time finding the full pinout for this PS. Did you find that two of those pins are PS ON/Kill? I suspect the top two, but don't want to remove my soldering until I'm ready to wire up the switch.


I would also like to see the full pin layout as well as add a switch. Can I use an old power switch from an old PC case and plug it into the pins on the power supply? Or, should I add an inline switch? If so, would that go before or after the PSU?