1

Topic: Solidoodle 4 Upgrades?

I have searched for info for Upgrading my heat bed and power supply for my Solidoodle 4. All the information I have found has been for older models. I want a heat bed that extends all the way to the edge, I have been doing some larger prints and they have been warping about 2" from the edge of the build area. Im assuming I will need to upgrade my Power supply as well, which one would you recommend?

Solidoodle 4-E3D V6- Rumba-Glass Bed-Upgraded PSU

2

Re: Solidoodle 4 Upgrades?

Since the SD4 is basically the same as an SD3 any of those mods will be interchangeable.
Many users have been happy with this PSU
http://www.amazon.com/gp/aw/d/B009EIANT … VSV2RCE7CE
As far as bed heaters go that all comes down to wattage and deciding how involved you want to get.
I have had decent results with this one but it will only be as good as the power fed to it.
http://www.soliforum.com/topic/6181/sil … idoodle-3/

Of course for the ultimate bed heater set up I prefer 500 watts of AC power but only reccomend that for the electrically savy users.  Notice my signature.

Printit Industries Model 8.10 fully enclosed CoreXY, Chamber heat
3-SD3's & a Workbench all fully enclosed, RH-Slic3r Win7pro, E3D V6, Volcano & Cyclops Hot End
SSR/500W AC Heated Glass Bed, Linear bearings on SS rods. Direct Drive Y-axis, BulldogXL
Thanks to all for your contributions