Topic: Cheap nozzle DIY $14-$18
Shopping for:
1/2 or 15mm brass end plug (measured by inner diameter) $5.00
5/8 or 15.8mm internal snap ring (look up user wolverine-diesel on ebay to get 4 for $3.00)
250 Microns Stainless Steel Kief Screen (search on ebay to buy an entire sheet) $3.00
(I think 250 microns is exactly what you get from hose washer screen. It cost about the same)
(I personaly use 2 layers of 5/8 round hose washer screens for $3.00)
PICTURE BELOW uses hose washer screens.
Drill bit to what ever size is normally around 2-3 dollars each
Drill the plug thru the center and on the side for the termistor
Insert the cut out screen into the nozzle
secure with a snap ring (this is a home made snap ring from washer. Buy correct one please)
Screen you buy will last for many many uses as well as getting extra snap rings, so in a long run its much cheaper then $14-$18. Second nozzle will only cost you the cost of the plug $5.00, you will have everything else already.
I have different nozzle for different materials because they produce different diameter. It helps allot to have more nozzles then one or even two.
God Bless !
my 3d models http://www.turbosquid.com/Search/Artists/tonycstech