1 Topic by Stevos758

  • Stevos758
  • Member
  • Offline
  • Registered: 2013-04-22
  • Posts: 502

Topic: Filament Sub Forum

There are enough types of ABS, PLA, Nylon,Tglase/PETT, Rubbery, Support filaments out there I think it would be beneficial to have a sub forum for it all.

I always see them scattered all over but never in one place.

Website - http://rippsgaragetech.com/
Facebook - https://www.facebook.com/pages/Ripps-Ga … 3131469591
E3D V6 Bulldog XL mounts! http://www.filastruder.com/products/e3dv6-bulldog-mount

2 Reply by DePartedPrinter

  • DePartedPrinter
  • Moderator
  • Offline
  • From: Colorado
  • Registered: 2012-08-14
  • Posts: 1,478

Re: Filament Sub Forum

this is what i wanted with this...kind of

http://www.soliforum.com/topic/650/filament-reviews/

SD2 with E3D, SD Press, Form 1+
Filastruder
NYLON (taulman): http://www.soliforum.com/topic/466/nylon/

3 Reply by Stevos758

  • Stevos758
  • Member
  • Offline
  • Registered: 2013-04-22
  • Posts: 502

Re: Filament Sub Forum

That would be fine with me!

Website - http://rippsgaragetech.com/
Facebook - https://www.facebook.com/pages/Ripps-Ga … 3131469591
E3D V6 Bulldog XL mounts! http://www.filastruder.com/products/e3dv6-bulldog-mount

4 Reply by josefcub

  • josefcub
  • josefcub
  • Member
  • Offline
  • From: San Antonio, TX
  • Registered: 2014-01-22
  • Posts: 47

Re: Filament Sub Forum

I second (fourth?) this.  It'd be a handy place to easily share impressions of the filament we purchase, and let us have more than a single topic on the subject.

josefcub's Website

5 Reply by frozensoda

  • frozensoda
  • frozensoda
  • Member
  • Offline
  • From: Rockford, Illinois
  • Registered: 2013-01-25
  • Posts: 202

Re: Filament Sub Forum

+1

I edit my posts a lot.

6 Reply by bill50here

  • bill50here
  • bill50here
  • Member
  • Offline
  • Registered: 2013-10-21
  • Posts: 16

Re: Filament Sub Forum

I sure could use filimental input here! no pun intended,naw it was a shot folks but yes we need people to give views.I use octave 1.75mm 1kg spool and it mic's that is measures actual dia of 1.83 so i use offset in reptier to compensate.I run stock sd2 and hothead is running 195 consistant now troubles there.I had run 200 but it ws a bit hot and 5 deg ooler at 195 works for me. the color is white,I have red green blue but not tested them yet.