Topic: FilaWinder Documentation
STLs-
https://www.dropbox.com/s/dxenesobsn09n … s.zip?dl=1
Assembly Manual-
https://dl.dropboxusercontent.com/s/u6l … 1400126234
Assembly Videos-
http://www.youtube.com/watch?v=Cdzc6wZ_qTE
http://www.youtube.com/watch?v=bXzrUiHrQAg
http://www.youtube.com/watch?v=FvaWGfeOzWw
Setup and Operation-
https://dl.dropboxusercontent.com/s/45u … v5Zgyiwrlw
http://www.youtube.com/watch?v=uWDkBzS0 … e=youtu.be
Current Firmware- The winder comes programmed, but you can use these files if you want to make changes.
FilaWinder_v11 Is the current default firmware. Use a jumper to enter 3mm mode, and use a jumper to turn troubleshooting mode on.
https://www.dropbox.com/s/1mg6rnx1rhndo … 1.zip?dl=0
3mm Mode-
Place a jumper on the pair of pins at D12 to set the guide movement to 3mm.
Troubleshooting Mode-
Place a jumper on the pair of pins at D11 (next to the jumper shown in the picture above) to enter troubleshooting mode.
Go in the Arduino software to Tools / Serial Monitor to get a display of the status of the buttons and other functions. You can continue to run the winder in troubleshooting mode, but be aware that the sensor responds a little slower. If the filament gets jerked away from the sensor suddenly, it may not notice and keep the motor running.