1 Topic by shields1.as

  • shields1.as
  • Member
  • Offline
  • Registered: 2014-09-02
  • Posts: 398

Topic: could someone slice a file for me

For some reason just this one file my compter wont slice. It's not even that big. I fact it did it a couple days ago and now when I have time to print it I can't get it to slice. I have a SD3 and wanted to use .3 mm through Slic3r. I could send you all my setting if it would help. I'd greatly appreciate any help.

2 Reply by Tin Falcon

  • Tin Falcon
  • Tin Falcon
  • Member
  • Offline
  • From: New Jersey, USA
  • Registered: 2014-08-01
  • Posts: 2,424

Re: could someone slice a file for me

have you tried cura and or a repair program???

Soliddoodle 4 stock w glass bed------Folger Tech Prusa 2020 upgraded to and titan /aero extruder mirror bed
FT5 with titan/ E3D Aero------MP mini select w glass bed
MP Utimate maker pro-W bondtech extruder
Marlin/Repetier Host/ Slic3r and Cura

3 Reply by heartless

  • heartless
  • heartless
  • Member
  • Offline
  • From: Northcentral Wisconsin
  • Registered: 2015-04-08
  • Posts: 2,152

Re: could someone slice a file for me

I can certainly try it for you, but I don't recommend using 0.3mm as your layer height. Due to the 5/16" threaded rod, a 0.3mm layer height is not optimal - should try using 0.2963 instead.

SD4 #1 & #2 - Lawsy carriages, E3D v6, Rumba controller board, mirror bed plate, X motor fan, upgraded PSU & Mica bed heater
SD4 #3 - in the works ~ Folgertech FT-5, rev 1
Printit Industries Beta Tester - Horizon H1