1 Topic by ttschabos

  • ttschabos
  • Newbie
  • Offline
  • Registered: 2017-02-05
  • Posts: 3

Topic: Da Vinci Pro uneven bed

Hi,

I have a Da Vinci Pro and had a lot of troubles yet. I did the calibration according to this forum here with a piece of paper, but It looks like the alu bed is bent. Near the edge of the bed, the nozzle has a distance about 0.05mm, where in the middle, the distance to the bed is around 0.3mm. Does anyone else has this problem?

2 Reply by Hecot

  • Hecot
  • Member
  • Offline
  • Registered: 2016-02-29
  • Posts: 59

Re: Da Vinci Pro uneven bed

I had the same - XYZ seems to squeeze out every penny from manufacturing costs! I replaced with Borosilicat glas Heatbed: https://www.amazon.de/dp/B00SWIX0ZY/ref … MybZZ0179X

It got slightly bigger dimensions 213*200*3mm - but you can put it on top of the old glas or mill out the edges of the bed holder to make it fit (this is what I did).