1 (edited by frank28 2017-01-06 18:59:22)

Topic: How do i re-set the spool to 100m (changed page 09 using ntag hack)

Hi,

Sorry for newb question, but i have used the ntag hack (thanks guys) on here, pack code to follow, but when i reset page 09 using the write command it still says 000 remaining (as in the photo enc)

I am doing something wrong or can someone advise please,?


Thanks

Frank28http://soliforum.com/i/?oFCAh8p.jpg

Da Vinci Junior 1.0

2

Re: How do i re-set the spool to 100m (changed page 09 using ntag hack)

Hi Frank

I'm also very new with the DaVinci Printers, only reading what I've come across here on the forum so I might be completely wrong with what I'm about to say if so I'm sorry.

Is page 9 the correct page to reset?

From http://www.soliforum.com/topic/15815/xy … w-hacking/ it seems to me that you need to leave 9 alone.

You can modify 10 and 11 to be the same, and the remaining filament is in page 20. You then need to check that 21,22,23 are correct (a hash value of the remaining filament).

On the linked page they indicate you can use the following values to set your spool to 300m
10,11 E0930400
20    E0930400
21    A8813654
22    F03FEECE
23    F26E4D76

3

Re: How do i re-set the spool to 100m (changed page 09 using ntag hack)

Hi Frank

Just an update on this.

http://soliforum.com/i/?UM1xgpF.jpg

Those values work like a charm.

Just don't be an idiot like me when setting the values. In the RFID NFC Tool, the addresses are entered in HEX and not in decimal, so I wrote the wrong addresses first (The Addresses given in the post are in decimal)

But everything is working fine now.

4

Re: How do i re-set the spool to 100m (changed page 09 using ntag hack)

sosiowrath wrote:

Hi Frank

Just an update on this.

http://soliforum.com/i/?UM1xgpF.jpg

Those values work like a charm.

Just don't be an idiot like me when setting the values. In the RFID NFC Tool, the addresses are entered in HEX and not in decimal, so I wrote the wrong addresses first (The Addresses given in the post are in decimal)

But everything is working fine now.


Thank for that, sending you pm if thats ok