1 Topic by Chaparro1973

  • Chaparro1973
  • Newbie
  • Offline
  • Registered: 2016-04-12
  • Posts: 9

Topic: Help X axis stops

I have the following setup

Board : GT2560 (also tryed with ramps, but the same)

Drivers:

DRV8825 for x, y, and z axis

A4988 for the extruder

Firmware Marlin and repetier

Everything is working fine until i star printing, after a few layers (usualy 3 or 4 layers) the x axis just stops, and even if i reset the board wont move.

The only way it gets working agains is if i unplug everything and start over.

Checked voltage on the drivers and endstops and it seams ok just before starting to print.

Can someone give me a hand please?

2 Reply by Tin Falcon

  • Tin Falcon
  • Tin Falcon
  • Member
  • Offline
  • From: New Jersey, USA
  • Registered: 2014-08-01
  • Posts: 2,424

Re: Help X axis stops

Check x axis wiring

Soliddoodle 4 stock w glass bed------Folger Tech Prusa 2020 upgraded to and titan /aero extruder mirror bed
FT5 with titan/ E3D Aero------MP mini select w glass bed
MP Utimate maker pro-W bondtech extruder
Marlin/Repetier Host/ Slic3r and Cura

3 Reply by Chaparro1973

  • Chaparro1973
  • Newbie
  • Offline
  • Registered: 2016-04-12
  • Posts: 9

Re: Help X axis stops

Checked all the wiring and it seams ok (anyway i will be making new wiring becouse its an upgraded version, larger, and i want to make the conection in one piece with no weldin betwen)
I have earlier checked the power on the chip, now i have changed to a A4988 and testing.
so managed to print 3 pieces (suports for the gt2560 board with cooling) and it seams ok