Topic: Davinci jr print head digging into protective tape
My davinci junior is digging into the protective tape covering the build plate. Any ideas?
You are not logged in. Please login or register.
SoliForum - 3D Printing Community → 3D Printer Discussion → Davinci jr print head digging into protective tape
My davinci junior is digging into the protective tape covering the build plate. Any ideas?
My davinci junior is digging into the protective tape covering the build plate. Any ideas?
Your Z height is set wrong. Or the bed is unlevel. Have you tried calibration?
Did a factory reset but nothing changed, the z offset setting says .3mm
Z axis reads .1mm
This video shows how to adjust your Z offset, which I'm fairly sure is the problem with your printer.
SoliForum - 3D Printing Community → 3D Printer Discussion → Davinci jr print head digging into protective tape
Powered by PunBB, supported by Informer Technologies, Inc.