The error message is telling you the exact problem, MAX TEMP.
On an SD with a stock hotend it reads cold by 15-20 degrees due to the location of the thermistor. Because of this SD set the Max Temp in the firmware low to prevent damage to the hot end. I would recommend doing a PID auto tune to ensure it isn't over shooting during heat up. Then set your temp a little lower like 210 to help prevent it from reaching max temp. There are several mods that will allow higher temps for more exotic filament.
PID http://www.soliwiki.com/PID_tuning
The entire calibration section is a must read http://www.soliwiki.com/#Calibrations
When you're ready for the best hot end available https://www.printitindustries.com/colle … -assembled
For when you get tired of waiting an hour for your bed heater. https://www.printitindustries.com/colle … -8-heatbed
When your PSU finally fails, and it will https://www.printitindustries.com/produ … wer-supply
Spend some time in the Hacks and Mods section if you really want to make your SD print well. Ask lots of questions as there are many of us that have been in your position. Make it fun and learn a lot along the way. There are many modifications that cost little to nothing that can really improve your printer.
Hope that helps and as always, Happy Printing!
Printit Industries Model 8.10 fully enclosed CoreXY, Chamber heat
3-SD3's & a Workbench all fully enclosed, RH-Slic3r Win7pro, E3D V6, Volcano & Cyclops Hot End
SSR/500W AC Heated Glass Bed, Linear bearings on SS rods. Direct Drive Y-axis, BulldogXL
Thanks to all for your contributions