Topic: tracking/calibration issue? Print not correct
When laying down my raft.
It's as though the co ordinates are messed up. It almost trails back the same route after traveling toward the back of the printer.
You can see what I mean in the picture.
The pattern should be uniform. Move left, then diagonal back. then down. diagonal forward.
Instead, on the return forward, it goes back, then forward over the same bit, then diagonal forward almost on the same bath it just went down.
What's weird is at the front, it is fine, and its the same direction?
Any ideas?
The pattern should be the same on both ends.
The wire loom tested continuity, bearing moves easily enough