1 (edited by andysus 2016-12-03 11:03:44)

Topic: Solidoodle 2 pro into rumba marlin firmware

Hello my solidoodle 2 is broken so i buy a RUMBA and I do all connection. Now i put a firmware Marlin 1.0.2-2, but i don't have any idea for configuration.
when i put into define board RUMBA, this is the error: "pasting "DIO" and "-" does not give a valid preprocessing token"

Solidoodle 2 Pro + Glass Bed

2

Re: Solidoodle 2 pro into rumba marlin firmware

please do not post the same issue in multiple locations - you have basically the same post in the Software and Firmware section.

SD4 #1 & #2 - Lawsy carriages, E3D v6, Rumba controller board, mirror bed plate, X motor fan, upgraded PSU & Mica bed heater
SD4 #3 - in the works ~ Folgertech FT-5, rev 1
Printit Industries Beta Tester - Horizon H1