1

Topic: (S4) PLA fan duct for Lawsy carriage and Lite6?

Greetings,
I posted a while ago about switching to PLA and looking for a fan duct for my S4. it has a E3D Lite6 with Lawsy carriages.
I saw Ticktock has a really good one for the S4 with stock carriages and wondering if there is a carriage that will fit or if I could just cut the bottom of my stock metal bracket and use ticktock's duct ok? like will clearance be ok or if anyone has done this?

Thank you

2

Re: (S4) PLA fan duct for Lawsy carriage and Lite6?

http://www.thingiverse.com/thing:154544
I use this on two printers...one with a Lite6 and the other a v6, but but have a Volcano block which adds extra length similar to the v5 this was designed for.

Print this up in ABS. If it doesn't clear, it is nothing a Dremel or safe use of a razor can't fix.

Printit Mason and Printit Horizon printers
Multiple SD2s- Bulldog XL, E3D v5/v6/Lite6, Volcano, Hobb Goblin, Titan, .9 motor, Lawsy carriages, direct Y drive, fishing line...the list goes on
Filawinder and Filastruder #1870.....worth every penny!

3

Re: (S4) PLA fan duct for Lawsy carriage and Lite6?

AZERATE wrote:

http://www.thingiverse.com/thing:154544
I use this on two printers...one with a Lite6 and the other a v6, but but have a Volcano block which adds extra length similar to the v5 this was designed for.

Print this up in ABS. If it doesn't clear, it is nothing a Dremel or safe use of a razor can't fix.

Is there one that uses a 40x10 fan? only because I have an extra one I dont use. But if not then ill defiantly use that one you linked