1

Topic: Uploaded Successfully

Last night I uploaded Solidoodle-Marlin_v1 firmware for the first time using Arduino 022 IDE. I followed the steps from one of the other threads and was stuck for a bit trying to use 1.0.5 as suggested but going back to the older IDE worked. Is this the favorite firmware? Anything newer out there? I didn't have room for Z hysteresis and wobble so I just loaded wobble as I'm having tons of issues with my prints and have already put spring loaded fix onto Z axis.

https://github.com/ozadr1an/Solidoodle- … in_v1_beta

^-- this is the version I uploaded after updating configuration header and recompiling -- apparently it's like 3 years old so I thought there must be something newer?

Post's attachments

SuccessfulFirstFirmwareUpload022.PNG
SuccessfulFirstFirmwareUpload022.PNG 97.54 kb, 1 downloads since 2016-10-27 

You don't have the permssions to download the attachments of this post.
SD2 Pro + RH + Slic3r on Win7Ent (~Craigslist Oct. 2016 my 1st printer: upgrading & calibrating to near perfection)
- E3D V6 hotend; 30A PSU; Glass bed for ABS or Blue Tape on glass for PLA
- X-axis NEMA 14 press on fan (thing:1871741); Lawsy almost everything else; 3mm Z axis rod (thing:1868824)
- Sang board w/all headers, ATmega1284P w/OptiBoot and Marlin beta firmware; VRef tuned

2

Re: Uploaded Successfully

It's old but so is your printer wink
That's the best version for your current setup in a pre configured form.
You could pull the latest version of Marlin from Git and set it up for your machine.  I have done this and you will notice little to no improvement from your printer.  There's only so much firmware can fix.

Printit Industries Model 8.10 fully enclosed CoreXY, Chamber heat
3-SD3's & a Workbench all fully enclosed, RH-Slic3r Win7pro, E3D V6, Volcano & Cyclops Hot End
SSR/500W AC Heated Glass Bed, Linear bearings on SS rods. Direct Drive Y-axis, BulldogXL
Thanks to all for your contributions

3

Re: Uploaded Successfully

Sage advice. Thank you! smile

wardjr wrote:

It's old but so is your printer wink
That's the best version for your current setup in a pre configured form.
You could pull the latest version of Marlin from Git and set it up for your machine.  I have done this and you will notice little to no improvement from your printer.  There's only so much firmware can fix.

SD2 Pro + RH + Slic3r on Win7Ent (~Craigslist Oct. 2016 my 1st printer: upgrading & calibrating to near perfection)
- E3D V6 hotend; 30A PSU; Glass bed for ABS or Blue Tape on glass for PLA
- X-axis NEMA 14 press on fan (thing:1871741); Lawsy almost everything else; 3mm Z axis rod (thing:1868824)
- Sang board w/all headers, ATmega1284P w/OptiBoot and Marlin beta firmware; VRef tuned