1

Topic: Bricked Da Vinci 1.1 plus

Hopefully i can recover my bricked 1.1 plus, i reset the chip and the realised that 1.1 plus is not supported with the non OEM firmware.

I would be greatful for any ideas to recover thos unit.

Thanks in advance.

2

Re: Bricked Da Vinci 1.1 plus

If you are feeling adventurous, you could always try swapping out the controller board & firmware for something open source... tongue

SD4 #1 & #2 - Lawsy carriages, E3D v6, Rumba controller board, mirror bed plate, X motor fan, upgraded PSU & Mica bed heater
SD4 #3 - in the works ~ Folgertech FT-5, rev 1
Printit Industries Beta Tester - Horizon H1

3

Re: Bricked Da Vinci 1.1 plus

:-) drop from a second story window would be more fun :-)

4

Re: Bricked Da Vinci 1.1 plus

polarnomad wrote:

:-) drop from a second story window would be more fun :-)

LOL, most likely. big_smile

SD4 #1 & #2 - Lawsy carriages, E3D v6, Rumba controller board, mirror bed plate, X motor fan, upgraded PSU & Mica bed heater
SD4 #3 - in the works ~ Folgertech FT-5, rev 1
Printit Industries Beta Tester - Horizon H1

5 (edited by epicdoom 2016-09-27 00:05:41)

Re: Bricked Da Vinci 1.1 plus

ive read elsewhere that holding the up and down buttons on the face of the unit while powering it up will bring it to bootloader as well some say left and right held at power up .... worth a try